Messages displayed when there are communication interruptions between the rPAC or RTU and the Modbus RTU Slave or Modbus/TCP Server. The following system diagnostic filters can be individually enabled or disabled, and are retained in non-volatile memory.ĭisplays Modbus protocol data transmitted by the Modbus RTU Master or Modbus/TCP Client.ĭisplays Modbus protocol data received by the Modbus RTU Master or Modbus/TCP Client. As a result, you may want to disable diagnostics when not in use. Using diagnostics can impact system performance. Where: filter = * TX RX ERROR TCP_CLIENT SERIAL_MASTER To enter or return to a diagnostic display session, type DIAG at the command prompt. Hexadecimal format is used to display protocol data bytes.
#Cmd modbus poll serial
Use the MODBUSDIAG command to filter Modbus protocol diagnostics when you are in a diagnostic display session and the rPAC or RTU is operating as a Modbus RTU Master or a Modbus/TCP Client.Ī Modbus RTU Master communicates with a Modbus RTU Slave using the Modbus RTU protocol over a serial port.Ī Modbus/TCP Client communicates with a Modbus/TCP Server using the Modbus/TCP protocol over an Ethernet port, or using PPP/TCPIP over a serial port. The example below will use “CMD Line” port mode.
The Diagnostic Command Line Interface can only be accessed via Telnet or a serial port configured as “CMD Line”. In cases where there might be a challenge communicating to a slave device, the Command line Interface and MODBUSDIAG may be used to troubleshoot the Modbus communication protocol. With the introduction of the Modbus Scanner in E-Series Utilities 8.12.4, the SCADAPack E is able to be a Modbus Master for Modbus RTU or Modbus/TCP Client protocols.
0 kommentar(er)
